WILD WMSX60 System on Module – WMSX60
Integrating the AMD Zynq UltraScale+™ RFSoC FPGA, the WILD WMSX60 System on Module is a SWaP-optimized low latency solution that delivers high-performance processing and one channel each of 5 GSps A/D and D/A converting at 14-bit resolution. It also includes two system monitor ADC channels.
Want more ADC/DAC channels and higher rates and Direct RF capability? See the WILDSTAR SAF1 Small Form Factor Module.
This Small Form Factor Module is readily deployed as a standalone unit for edge applications close to the sensor and in other tight envelope man-portable environments. The System-On-Module (SoM) form factor is ideal for SWaP-critical deployments.
Annapolis’ powerful BSP options include 40/100GbE IP and Linux support.
Review other OpenVPX and SOSA™-aligned boards.
General
- Integrates AMD Zynq® UltraScale+™ RFSoC FPGA: ZU48DR SCD with Defeaturing
- PCIe, GTY, and CMAC disabled
- ADC Banks 225, 226, and 227 disabled
- 552 System Logic Cells (K)
- 505 CLK Flip-Flops (K)
- 253 CLB LUTs (K)
- 22.7Mb of Total Block Ram
- 9.0Mb of UltraRam
- 2582 DSP Slices
- Ultra-low latency from ADC RF input to DAC RF output
- One high-performance ADC channel
- Two system monitor ADC channels
- One high-performance DAC channel
ADC and DAC Performance
- ADC
- Channels: 1
- Max Sample Rate: 5.0GSps
- Resolution: 14 bit
- System Monitor ADC
- Max Sample Rate: 0.2MSps
- Resolution: 10 bit
- DAC
- Channels: 1
- Max Sample Rate: 8.92GSps
- Resolution: 14 bit
I/O Connectors
- 50Ω SMPM Board-Board Analog Connectors
- Eleven I/O Connectors
- One Analog Input
- Two System Monitor Analog Inputs
- One Analog Output
- JTAG Connector
- UART Connector
- Debug GPIO Connector
- Mezzanine Connector
Clock Synchronization
- Onboard PLL clock with DCTCXO reference
Mechanical and Environmental
- Commercial and Industrial Temperatures Available
The following documentation is available for registered users of our site. Please log in or feel free to register for our site.
Technical Documents
For additional documentation, please contact your Sales Representative.